So, I have ellipses given – they are defined by their midpoint, an horizontal radius(rh) and an vertical radius(rv). I’m drawing them using sin/cos and the result looks fairly good to me(just making sure this isn’t an error source).
Now say I have an angle(or a direction vector) given and I want to have the point on the ellipse’s outline with that angle/direction. My intuitive approach was to simply use the direction vector, normalise it and multiply its x-component with rh, its y-component with rv. Now both my written program AND all the calculations I did on a paper give me not the point I want but another one, though it’s still on the ellipse’s outline. However, this method works just fine if the direction is one of (1,0), (0, 1), (-1, 0), (0, -1), (so it works for 0°, 90°, 180°, 270°).
Although there is a farily big amount of data about ellipses themselves on the internet, I couldn’t find any information about my particular problem – and I couldn’t come up with any better solution than the above one.
So, any idea how to achieve this?
If I understand what you are asking then I think that what you need is polar form of an ellipse where the angle is measured from the ellipse centre. Using this form of the ellipse, you will be able to evaulate your elliptic radius value for a given choice of theta and then plot your point.
If you take a look at this gif image you will see why using the parametric angle give you the correct result only at theta = 90, 180, 270 and 360 degrees http://en.wikipedia.org/wiki/File:Parametric_ellipse.gif . Use the polar form for an ellipse and you should get the points that you want.