I am trying to determine approximate time delay (Win 7, Vista, XP) to switch threads when an IO operation completes.
What I (think I) know is that:
a) Thread contex switches are themselves computationally very fast. (By very fast, I mean typically way under 1ms, maybe even under 1us? – assuming a relatively fast, unloaded machine etc.)
b) Round robin time slice quantums are on the order of 10-15ms.
What I can’t seem to find is information about the typical latency time from a (high priority) thread becoming active/signaled – via, say, a synchronous disk write completing – and that thread actually running again.
E.g., I have read in at least one place that all inactive threads remain asleep until ~10ms system quantum expires and then (assuming they are ready to go), they all get reactivated almost synchronously together. But in another place I read that the delay between when a thread completes an I/O operation and when it becomes active/signaled and runs again is measured in microseconds, not milliseconds.
My context for asking is related to capture and continuous streaming write to a RAID array of SSDs, from a high speed camera, where unless I can start a new write after a prior one has finished in well under 1ms (it would be best if under 1/10ms, on average), it will be problematic.
Any information regarding this issue would be most appreciated.
Thanks,
David
Thread context switches cost between 2,000 and 10,000 cpu cycles, so a handful of microseconds.
An I/O completion is fast when a thread is blocking on the synchronization handle that signals completion. That makes the Windows thread scheduler temporarily boost the thread priority. Which in turn makes it likely (but not guaranteed) to be chosen as the thread that gets the processor love. So that’s typically microseconds, not milliseconds.
Do note that disk writes normally go through the file system cache. Which makes the WriteFile() call a simple memory-to-memory copy that doesn’t block the thread. This runs at memory bus speeds, 5 gigabytes per second and up. Data is then written to the disk in a lazy fashion, the thread isn’t otherwise involved or delayed by that. You’ll only get slow writes when the file system cache is filled to capacity and you don’t use overlapped I/O. Which is certainly a possibility if you write video streams. The amount of RAM makes a great deal of difference. And SSD controllers are not made the same. Nothing you can reason out up front, you’ll have to test.