I currently have an embedded device connected to a PC through a serial port. I am having trouble with receiving data on the PC. When I use my PCI serial port card I am able to receive data right away (no delays). When I use my USB-To-Serial plug or the motherboards built in serial port I have to delay reading data (40ms for 32byte packets).
The only difference I can find between the hardware is the UART. The PCI card uses a 16650 and the plug/motherboard uses a standard 16550A. The PCI card is set to interrupt at 28 bytes and the plug is set to interrupt at 14 bytes.
I am connected at 56700 Baud (if this helps).
The delay becomes the majority of the duty cycle and really increases transfer time. (10min transfer vs 1 hour transfer).
Does anyone have an explanation for why I have to use a delay with the plug/motherboard? Can anyone suggest a possible solution to minimizing or removing this delay?
Linux has an ASYNC_LOW_LATENCY flag for the serial driver that may help. Whatever driver you’re using may have something similar.
However, latency shouldn’t make a difference on a bulk transfer. It should add 40 ms at the very start of the transfer and that’s it, which is why drivers don’t worry about it in the first place. I would recommend refactoring your transfer protocol to use a sliding window protocol, with a window size of around 100 packets, if you are doing 32-byte packets at that baud rate and latency. In other words, you only want to stop transmitting if you haven’t received an ACK for the packet you sent 100 packets ago.