I have a data acquisition application running on Windows 7, using VC2010 in C++. One thread is a heartbeat which sends out a change every .2 seconds to keep-alive some hardware which has a timeout of about .9 seconds. Typically the heartbeat call takes 10-20ms and the thread spends the rest of the time sleeping.
Occasionally however there will be a delay of 1-2 seconds and the hardware will shut down momentarily. The heartbeat thread is running at THREAD_PRIORITY_TIME_CRITICAL which is 15 for a normal priority process. My other threads are running at normal priority, although I use a DLL to control some other hardware and have noticed with Process Explorer that it starts several threads running at level 15.
I can’t track down the source of the slow down but other theads in my application are seeing the same kind of delays when this happens. I have made several optimizations to the heartbeat code even though it is quite simple, but the occasional failures are still happening. Now I wonder if I can increase the priority of this thread beyond 15 without specifying REALTIME_PRIORITY_CLASS for the entire process. If not, are there any downsides I should be aware of to using REALTIME_PRIORITY_CLASS? (Other than this heartbeat thread, the rest of the application doesn’t have real-time timing needs.)
(Or does anyone have any ideas about how to track down these slowdowns…not sure if the source could be in my app or somewhere else on the system).
Update: So I hadn’t actually tried passing 31 into my AfxBeginThread call and turns out it ignores that value and sets the thread to normal priority instead of the 15 that I get with THREAD_PRIORITY_TIME_CRITICAL.
Update: Turns out running the Disk Defragmenter is a good way to cause lots of thread delays. Even running the process at REALTIME_PRIORITY_CLASS and the heartbeat thread at THREAD_PRIORITY_TIME_CRITICAL (level 31) doesn’t seem to help. Next thing to try is calling AvSetMmThreadCharacteristics(“Pro Audio”)
Update: Scheduling heartbeat thread as “Pro Audio” does work to increase the thread’s priority beyond 15 (Base=1, Dynamic=24) but it doesn’t seem to make any real difference when defrag is running. I’ve been able to correlate many of the slowdowns with the disk defragmenter so turned off the weekly scan. Still can’t explain some delays so we’re going to increase to a 5-10 second watchdog timeout.
Even if you could, increasing the priority will not help. The highest priority runnable thread gets the processor at all times.
Most likely there is some extended interrupt processing occurring while interrupts are disabled. Interrupts effectively work at a higher priority than any thread.
It could be video, network, disk, serial, USB, etc., etc. It will take some insight to selectively disable or use an alternate driver to see if the problem system hesitation is affected. Once you find that, then figuring out a way to prevent it might range from trivial to impossible depending on what it is.
Without more knowledge about the system, it is hard to say. Have you tried running it on a different PC?