I have a dsPIC33 with ECAN and wish to establish a protocol (using SDO if possible) in such way that it communicate between terminal software and dsPIC33 where I can perform diagnostics within dsPIC33 and supporting ICs.
I do not know what is required, so what is a low cost way of doing this? I could use a CAN-to-USB device, but I am unsure if this will work. What kind of protocol inside CANUSB wraps around the ASCII-based message?
What hardware can I use? Can it be used to monitor the CAN bus as well? I do not wish to invest in an expensive setup as in Vector or similar heavy-weight solution.
You can download an open source project for CANopen from DATALINK ENGINEERING as this seems to be just what you need.