Question

I have a fairly complex application in Delphi 2006 that communicates through an ApdComport using a separate form in another thread. The communication used to fail quite a lot and I found a couple of calls to Application.Processmessages in the loops and reconstructed it using the ApdComport.ProcessCommunications instead.

I don’t really want to rearrange the code to use event handlers instead at this point.

I also want to make the communication fast so I call ProcessCommunications until there is a CharReady. Sometimes ProcessCommunications raises an ECommNotOpen exception with the message “ie_NOpen – device not open”. I’ve been unable to find info about this in the help or on the web.

I tried putting an ApdComport on a new form in a new project and call its ProcessCommunications frequently and could not get it to crash. It did not do any real communication though.

I have tried checking that the output buffer has enough free space before sending stuff but it always has and the problem is still there.

So what is happening? Where should I look and what can I do?

Answer 1

Are you using a pre 4.06 version?

Search for “ie_NOpen” at this page: http://www.turbocontrol.com/APRO406Fixes.htm

This is the extracted info:

fix 3941 State machine accesses port
after closing

The state machine will access the port
when deactivated to write to the
dispatcher log. This can cause an
ie_NOpen exception under some
conditions. To fix, make the
following change to AdStMach.pas
marked by {!!.06}

procedure TApdStateComPortSource.StateDeactivate (State : TApdCustomState);
begin
  if FComPort.Open then                                                  {!!.06}
    FComPort.AddStringToLog (Name + ': Deactivate');
end;