Home/ Questions/Q 1078147
In Process

The Archive Base Latest Questions

Editorial Team
  • 0
Asked: 2026-05-16T21:40:50+00:00

I have a piece of hardware with an embedded user control accessed by typing

  • 0

I have a piece of hardware with an embedded user control accessed by typing the device’s IP Address into a web browser. The device is connected directly to my PC via x-over ethernet cable and static IP’s. I need to integrate the control of the device into my C# application.

My thought was to use a packet sniffer to monitor the traffic between my PC and the device while at the same time playing with the device’s controls in my web browser. Then finding out which packets that my PC is sending correspond with which controls I am using at that time. Then I can create a class of HTTP or TCP packets in my C# application and send them to the device using the Socket class.

However, I dont have much expereince with network protocols, so when I am using Wireshark to monitor the traffic between my PC and the device, I am not sure where to even start when finding out which packets do what. Does anyone have any ideas? I am open to anything. Thanks!!

EDIT:
Its hard to explain exactly what my device is, but its basically an elaborate sensor and typically used in industrial applications, so it could likely be using Modbus, which I am moderately familiar with. Do you know how I can tell which protocol is being used by examining the packets? I noticed (using Wireshark) that the packets being sent from my PC to the device occur in a pattern of 1 HTTP packet, then 5 TCP packets and repeat that same sequence as long as the control is open in my browser. Are there any resources that might give me a better understanding of what is going on?

Share

Leave an answer

You must login to add an answer.

Need An Account,

1 Answer

  1. Editorial Team

    If this is browser controlled, my first thought would be to examine the web pages the device sends to your browser and see what the browser is instructed to do when you manipulate the controls – this seems much easier than messing around with Wireshark.

    Is there something I’m missing that makes this impossible (such as a Flash-based control system)? If it’s just done with HTML or Javascript, and HTML POST messages or something a bit more sophisticated like Ajax, it should be relatively easy to work out the interface.

    • 0