I have a WinForms application that uses XNA to animate 3D models in a control. The app have been doing just fine for months but recently I’ve started to experience periodic pauses in the animation. Setting out to investigate what is going on I have established these facts:
- It happens on my machine only, other machines works fine
- Removing everything from my render loop does not improve the problem
In 2. I didn’t actually remove everything, I limited my loop to set the viewport on my GraphicsDevice and then do a GraphicsDevice.Present.
Trying to dig further I fired up PIX to capture some statistics. Screenshots of two PIX runs can be viewed here (Run6) and here (Run14). Run6 is using my original render loop and Run14 is using the bare-bones Present loop.
PIX tells me that the GPU is periodically doing something, and I assume this is causing the pauses. What could be the cause of this? Or how do I go about finding out what the GPU is actually doing?
Update: since I usually trust my code to be perfect (who’s laughing?) I started a new XNA project from scratch to see if it exhibit the same behavior. So starting a new XNA 3.1 Windows Game project and running PIX I get this timeline. The same periodic pauses. So the problem must be lower in the stack, in XNA or Direct3D.
So PIX shows that the GPU is working on something, I can see the list of DX calls made within each frame and the timing calculations shows that the pause occurs during (or after) the IDirect3DDevice9::Present call.
Update 2: I had previously installed and uninstalled XNA 4.0 CTP on the problematic machine. I cannot be certain that this is related but I thought that perhaps a reinstall of the XNA Game Studio 3.1 bits could make a difference. Turns out it did.
The underlying question remains the same (and the bounty is still up): what could affect XNA 3.1 (or DirectX) to make it behave like this and is there any logging/tracing power tool for the DirectX and/or GPU level out there that could shed some light on what is going on?
Note: I’m using XNA 3.1 on a Windows 7 x64 dual-core machine with 8GB RAM.
Note2: also posted this question on the XNA Creators forums here.
You could try to see if you can find something with Xperf that is close to your periodically problem, do not run your application but keep the programs open that would normally run besides your application. You could also try to do it again with the application running but it could give a cluttered view.
Wait for a fair amount of time to be sure that the problem is traced.
Stop the tracing and open it like this.
Also more information on Xperf and how to obtain it, hopefully this delivers results.
If not, you can alternatively try GPUView which has been used for improvements in DWM,
this is also included next to Xperf with the Windows Performance Toolkit so you can easily try both!
In the case that gpuview gets out of memory you can try to add "/limit 3" or remove the v.
Read the documentation of the tools if you are stuck somewhere.