Home/ Questions/Q 7004403
In Process

The Archive Base Latest Questions

Editorial Team
  • 0
Asked: 2026-05-27T21:11:41+00:00

I just installed Delphi XE 2 and went through the whole installation process; however,

  • 0

I just installed Delphi XE 2 and went through the whole installation process; however, when I try to launch Delphi XE 2, I get the following error messages, and then nothing happens (Delphi XE 2 crashes or something and fails and no screens appear). I have already tried repairing, uninstalling and then reinstalling.

Error Message 1:

http://i41.tinypic.com/25m4y.jpg

Error Message 2:

http://i43.tinypic.com/2i1mfma.jpg

Error Message 3 + 4:

http://i41.tinypic.com/j6n410.jpg

Did something fail to register during the installation process? Any ideas on how to remedy this issue?

I have also asked this question on Embarcadero’s forums, but have yet to receive an answer. A bit of Googling revealed that this problem was asked before on Embarcadero’s forums, but the link is now dead.

Share

Leave an answer

You must login to add an answer.

Need An Account,

1 Answer

  1. Editorial Team

    In order to get Delphi to install correctly, I needed to install a few .NET 3.5-4.0 updates (apparently these were not marked for automatic download and installation), reboot, uninstall Delphi XE 2, and run the Delphi XE 2 installer as an Administrator.

    After doing this, Delphi XE 2 worked without a hitch.

    • 0