Question

I need to make some stream in and out classes using mmap() in Linux. To do so I tried to make some test code that writes some integers to a file, saves it, loads it again and write the data in the file to cout. If that test code works, then It wont be a problem making stream in and out afterwards.

When I first started out I got segment faults and If I did not get that nothing happened, so I googled a little. I found this book http://www.advancedlinuxprogramming.com/alp-folder/alp-ch05-ipc.pdf where around page 107 there is some usefull code. I copy pasted that code and made some small changes and got this code:

int fd;
void* file_memory;

/* Prepare a file large enough to hold an unsigned integer.  */
fd = open ("mapTester", O_RDWR | O_CREAT, S_IRUSR | S_IWUSR);

//Make the file big enough
lseek (fd, 4 * 10 + 1, SEEK_SET);
write (fd, "", 1);
lseek (fd, 0, SEEK_SET);

/* Create the memory mapping.  */
file_memory = mmap (0, 4 * 10, PROT_WRITE, MAP_SHARED, fd, 0);
close (fd);

/* Write a random integer to memory-mapped area.  */
sprintf((char*) file_memory, "%d\n", 22);

/* Release the memory (unnecessary because the program exits).  */
munmap (file_memory, 4 * 10);

cout << "Mark" << endl;

//Start the part where I read from the file

int integer;

/* Open the file.  */
fd = open (argv[1], O_RDWR, S_IRUSR | S_IWUSR);

/* Create the memory mapping.  */
file_memory = mmap (0, 4 * 10, PROT_READ | PROT_WRITE,
MAP_SHARED, fd, 0);
close (fd);

/* Read the integer, print it out, and double it.  */
scanf ((char *) file_memory, "%d", &integer);
printf ("value: %d\n", integer);
sprintf ((char*) file_memory, "%d\n", 2 * integer);

/* Release the memory (unnecessary because the program exits).  */
munmap (file_memory, 4 * 10);

But I get a segment fults after the “mark” cout.

Then I replace the “read part” with this:

fd = open("mapTester", O_RDONLY);

int* buffer = (int*) malloc (4*10);

read(fd, buffer, 4 * 10);

for(int i = 0; i < 1; i++)
{
    cout << buffer[i] << endl;
}

That is some working code that shows me that the file is empty. I tries out a couple of ways to write to the mapping without any change in result.

So how am I amble to make my code write?
And does my mmap read code seem okay (just in case you can see some obvious flaws)?

I have found some other resources that did not help me yet, but because I am a new user I may only post max 2 links.

Answer 1

You should test the result of mmap. If it gives MAP_FAILED check out errno to find out why.

And you’ll better mmap a multiple of pages, often 4K bytes each, and given by sysconf(_SC_PAGESIZE)

You can use stat to find out the size of (and many other numbers about) some given file.

You could use strace on existing Linux programs to learn what syscalls they are doing.

See also this about /proc/ etc.