Question

I understand how programs in machine code can load values from memory in to registers, perform jumps, or store values in registers to memory, but I don’t understand how this works for multiple processes. A process is allocated memory on the fly, so must it use relative addressing? Is this done automatically (meaning there are assembly instructions that perform relative jumps, etc.), or does the program have to “manually” add the correct offset to every memory position it addresses.

I have another question regarding multitasking that is somewhat related. How does the OS, which isn’t running, stop a thread and move on to the next. Is this done with timed interrupts? If so, then how can the values in registers be preserved for a thread. Are they saved to memory before control is given to a different thread? Or, rather than timed interrupts, does the thread simply choose a good time to give up control. In the case of timed interrupts, what happens if a thread is given processor time and it doesn’t need it. Does it have to waste it, can it call the interrupt manually, or does it alert the OS that it doesn’t need much time?

Edit: Or are executables edited before being run to compensate for the correct offsets?

Answer 1

A process is allocated memory on the fly, so must it use relative addressing?

No, it can use relative or absolute addressing depending on what it is trying to address.

At least historically, the various different addressing modes were more about local versus remote memory. Relative addressing was for memory addresses close to the current address while absolute was more expensive but could address anything. With modern virtual memory systems, these distinctions may be no longer necessary.

A process is allocated memory on the fly, so must it use relative addressing? Is this done automatically (meaning there are assembly instructions that perform relative jumps, etc.), or does the program have to “manually” add the correct offset to every memory position it addresses.

I’m not sure about this one. This is taken care of by the compiler normally. Again, modern virtual memory systems make make this complexity unnecessary.

Are they saved to memory before control is given to a different thread?

Yes. Typically all of the state (registers, etc.) is stored in a process control block (PCB), a new context is loaded, the registers and other context is loaded from the new PCB, and execution begins in the new context. The PCB can be stored on the stack or in kernel memory or in can utilize processor specific operations to optimize this process.

Or, rather than timed interrupts, does the thread simply choose a good time to give up control.

The thread can yield control — put itself back at the end of the run queue. It can also wait for some IO or sleep. Thread libraries then put the thread in wait queues and switch to another context. When the IO is ready or the sleep expires, the thread is put back into the run queue. The same happens with mutex locks. It waits for the lock in a wait queue. Once the lock is available, the thread is put back into the run queue.

In the case of timed interrupts, what happens if a thread is given processor time and it doesn’t need it. Does it have to waste it, can it call the interrupt manually, or does it alert the OS that it doesn’t need much time?

Either the thread can run (perform CPU instructions) or it is waiting — either on IO or a sleep. It can ask to yield but typically it is doing so by [again] sleeping or waiting on IO.