Home/ Questions/Q 912085
In Process

The Archive Base Latest Questions

Editorial Team
  • 0
Asked: 2026-05-15T17:19:16+00:00

I want to terminate a process group by sending SIGTERM to processes within it.

  • 0

I want to terminate a process group by sending SIGTERM to processes within it. This can be accomplished via the kill command, but the manuals I found provide few details about how exactly it works:

   int kill(pid_t pid, int sig);
   ...
   If pid is less than -1, then sig is sent to every  process  in
   the process group whose ID is -pid.

However, in which order will the signal be sent to the processes that form the group? Imagine the following situation: a pipe is set between master and slave processes in the group. If slave is killed during processing kill(-pid), while the master is still not, the master might report this as an internal failure (upon receiving notification that the child is dead). However, I want all processes to understand that such termination was caused by something external to their process group.

How can I avoid this confusion? Should I be doing something more than mere kill(-pid,SIGTERM)? Or it is resolved by underlying properties of the OS, about which I’m not aware?

Note that I can’t modify the code of the processes in the group!

Share

Leave an answer

You must login to add an answer.

Need An Account,

1 Answer

  1. Editorial Team

    Try doing it as a three-step process:

    kill(-pid, SIGSTOP);
kill(-pid, SIGTERM);
kill(-pid, SIGCONT);

    The first SIGSTOP should put all the processes into a stopped state. They cannot catch this signal, so this should stop the entire process group.

    The SIGTERM will be queued for the process but I don’t believe it will be delivered, since the processes are stopped (this is from memory, and I can’t currently find a reference but I believe it is true).

    The SIGCONT will start the processes again, allowing the SIGTERM to be delivered. If the slave gets the SIGCONT first, the master may still be stopped so it will not notice the slave going away. When the master gets the SIGCONT, it will be followed by the SIGTERM, terminating it.

    I don’t know if this will actually work, and it may be implementation dependent on when all the signals are actually delivered (including the SIGCHLD to the master process), but it may be worth a try.

    • 0