Question

I would like to check if a std::thread has finished execution. Searching stackoverflow I found the following question which addresses this issue. The accepted answer proposes having the worker thread set a variable right before exiting and having the main thread check this variable. Here is a minimal working example of such a solution:

#include <unistd.h>
#include <thread>

void work( bool* signal_finished ) {
  sleep( 5 );
  *signal_finished = true;
}

int main()
{
  bool thread_finished = false;
  std::thread worker(work, &thread_finished);

  while ( !thread_finished ) {
    // do some own work until the thread has finished ...
  }

  worker.join();
}

Someone who commented on the accepted answer claims that one cannot use a simple bool variable as a signal, the code was broken without a memory barrier and using std::atomic<bool> would be correct. My initial guess is that this is wrong and a simple bool is sufficient, but I want to make sure I’m not missing something. Does the above code need a std::atomic<bool> in order to be correct?

Let’s assume the main thread and the worker are running on different CPUs in different sockets. What I think would happen is, that the main thread reads thread_finished from its CPU’s cache. When the worker updates it, the cache coherency protocol takes care of writing the workers change to global memory and invalidating the main thread’s CPU’s cache so it has to read the updated value from global memory. Isn’t the whole point of cache coherence to make code like the above just work?

Answer 1

Someone who commented on the accepted answer claims that one cannot use a simple bool variable as a signal, the code was broken without a memory barrier and using std::atomic would be correct.

The commenter is right: a simple bool is insufficient, because non-atomic writes from the thread that sets thread_finished to true can be re-ordered.

Consider a thread that sets a static variable x to some very important number, and then signals its exit, like this:

x = 42;
thread_finished = true;

When your main thread sees thread_finished set to true, it assumes that the worker thread has finished. However, when your main thread examines x, it may find it set to a wrong number, because the two writes above have been re-ordered.

Of course this is only a simplified example to illustrate the general problem. Using std::atomic for your thread_finished variable adds a memory barrier, making sure that all writes before it are done. This fixes the potential problem of out-of-order writes.

Another issue is that reads to non-volatile variables can be optimized out, so the main thread would never notice the change in the thread_finished flag.

---

Important note: making your thread_finished volatile is not going to fix the problem; in fact, volatile should not be used in conjunction with threading – it is intended for working with memory-mapped hardware.