Question

I’d like to start messing around programming and building something with an Arduino board, but I can’t think of any great ideas on what to build. Do you have any suggestions?

Answer 1

I show kids, who have never programmed, or done any electronics before, to make a simple ‘Phototrope’, a light sensitive robot, in about a day. It costs under £30 (GBP) including Arduino, electronics and off-the-shelf mechanics. If folks really get into mobile robots, the initial project can grow and grow (which I feel is part of the fun).

There are international robot competitions which require relatively simple mechanics to get started, e.g. in the UK http://www.tic.ac.uk/micromouse/toh.asp

Ultimate performance require specially built machines (for lightness) , but folks would get creditable results with an Arduino Nano, the right electronics, and a couple of good motors.

A line following robot is the classic mobile robot project. The track can be as simple as electrical tape. Pololu have some fun videos about their near-Arduino 3PI robot. The sensors are about £1, and there are a bunch of simple motor+gearbox kits from lots of places for under £10. Add a few £ for motor control, and you have autonomous robot mechanics, in need of programming! Add an Infrared Remote receiver (about £1), and you can drive it around using your TV remote. Add a small solar cell, use an Arduino analogue input to measure voltage, and it can find the sun. With a bit more electronics, it can ‘feed’ itself. And so it gets more sophisticated. Each step might be no more than a few hours to a few days effort, and you’ll find new problems to solve and learn from.

IMHO, the most interesting (low-cost) competitions are maze solving robots. The international competition rule require the robot to explore a walled maze, usually using Infrared sensors, and calculate their optimal route. The challenges include keeping track of current position to near-millimeter accuracy, dealing with real world’s unpredictably noisy environment and optimising straight-line speed with shortest distance cornering.

All that in 16K of program, and 1K RAM, with real-time interrupt handling (as much as 100K interrupts/second for some motor systems), sensor sampling, motor speed control, and maze solving is an interesting programming challenge. (You might make it ‘easy’ with 32K of program, and 2K RAM 🙂

I’m working on a ‘constrained’ robot challenge (based on Arduino) so that robot performance is mainly about programming rather than having a big budget.