Question

I’m busy with programming a class that creates an index out of a text-file ASCII/BINARY.
My problem is that I don’t really know how to start. I already had some tries but none really worked well for me.
I do NOT need to find the address of the file via the MFT. Just loading the file and finding stuff much faster by searching for the key in the index-file and going in the text-file to the address it shows.

The index-file should be built up as follows:

KEY        ADDRESS  
  1        0xABCDEF    
  2        0xFEDCBA    
  .           .  
  .           .  

We have a text-file with the following example value:

1, 8752 FW,
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++, 
******************************************************************************, 
------------------------------------------------------------------------------;

I hope that this explains my question a bit better.
Thanks!

Answer 1

It seems to me that all your class needs to do is store an array of pointers or file start offsets to the key locations in the file.

It really depends on what your Key locations represent.

I would suggest that you access the file through your class using some public methods. You can then more easily tie in Key locations with the data written.

For example, your Key locations may be where each new data block written into the file starts from. e.g. first block 1000 bytes, key location 0; second block 2500 bytes, key location 1000; third block 550 bytes; key location 3500; the next block will be 4050 all assuming that 0 is the first byte.

Store the Key values in a variable length array and then you can easily retrieve the starting point for a data block.

If your Key point is signified by some key character then you can use the same class, but with a slight change to store where the Key value is stored. The simplest way is to step through the data until the key character is located, counting the number of characters checked as you go. The count is then used to produce your key location.