Question

I’m trying to determine the difference when I open serial port with hardware handshake and none handshake.

It seems that in both cases I have to control RTS/CTS signals (just tested it with one COM device).
So what the difference between opening serial port with hardware handshake and without handshaking?

From my previous understanding, when we work without handshaking, we don’t care about RTS/CTS and DTR/DSR signals. Just send and receive data whenever we want. Was I wrong?

One more question. Can we work without handshaking in full duplex mode only?

Answer 1

As you probably know, the issue is “flow control”. Like the Clash song “Should I stay or should I go?”.

RTS/CTS is hardware control. XON/XOFF is software control. Otherwise, “just keep going”.

This link might explain further:

http://www.lammertbies.nl/comm/info/RS-232_flow_control.html

I suspect that when you were asking about “handshaking” with respect to “duplex”, perhaps you meant this:

http://en.wikipedia.org/wiki/RS-232

In older versions of the specification, RS-232’s use of the RTS and
CTS lines is asymmetric: The DTE asserts RTS to indicate a desire to
transmit to the DCE, and the DCE asserts CTS in response to grant
permission. This allows for half-duplex modems that disable their
transmitters when not required, and must transmit a synchronization
preamble to the receiver when they are re-enabled.

‘Hope that helps!