Question

I’ve looked high and low for examples of implementing a language using the RPython toolchain, but the only one I’ve been able to find so far is this one in which the author writes a simple BF interpreter. Because the grammar is so simple, he doesn’t need to use a parser/lexer generator. Is there a front-end out there that supports developing a language in RPython?

Thanks!

Answer 1

I’m not aware of any general lexer or parser generator targeting RPython specifically. Some with Python output may work, but I wouldn’t bet on it. However, there’s a set of parsing tools in rlib.parsing. It seems quite usable. OTOH, there’s a warning in the documentation: It’s reportedly still in development, experimental, and only used for the Prolog interpreter so far.

Alternatively, you can write the frontend by hand. Lexers can be annoying and unnatural, granted (you may be able to rip out the utility modules for DFAs used by the Python implementation). But parsers are a piece of cake if you know the right algorithms. I’m a huge fan of “Top Down Operator Precedence parsers” a.k.a. “Pratt parsers”, which are reasonably simple (recursive descent) but make all expression parsing issues (nesting, precedence, associativity, etc.) a breeze. There’s depressingly little information on them, but the few blog posts were sufficient for me:

• One by Crockford (wouldn’t recommend it though, it throws a whole lot of unrelated stuff into the parser and thus obscures it),
• another one at effbot.org (uses Python),
• and a third by a sadly even-less-famous guy who’s developing a language himself, Robert Nystrom.