Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Login to our social questions & Answers Engine to ask questions answer people’s questions & connect with other people.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
What is the potential maximum speed for rs232 serial port on a modern PC? I know that the specification says it is 115200 bps. But i believe it can be faster. What influences the speed of the rs232 port? I believe it is quartz resonator but i am not sure.
This goes back to the original IBM PC. The engineers that designed it needed a cheap way to generate a stable frequency. And turned to crystals that were widely in use at the time, used in any color TV in the USA. A crystal made to run an oscillator circuit at the color burst frequency in the NTSC television standard. Which is 315/88 = 3.579545 megahertz. From there, it first went through a programmable divider, the one you change to set the baudrate. The UART itself then divides it by 16 to generate the sub-sampling clock for the data line.
So the highest baudrate you can get is by setting the divider to the smallest value, 2. Which produces 3579545 / 2 / 16 = 111861 baud. A 2.3% error from the ideal baudrate. But close enough, the clock rate doesn’t have to be exact. The point of asynchronous signalling, the A in UART, the start bit always re-synchronizes the receiver.
Getting real RS-232 hardware running at 115200 baud reliably is a significant challenge. The electrical standard is very sensitive to noise, there is no attempt at canceling induced noise and no attempt at creating an impedance-matched transmission line. The maximum recommended cable length at 9600 baud is only 50 feet. At 115200 only very short cables will do in practice. To go further you need a different approach, like RS-422’s differential signals.
This is all ancient history and doesn’t exactly apply to modern hardware anymore. True serial hardware based on a UART chip like 16550 have been disappearing rapidly and replaced by USB emulators. Which have a custom driver to emulate a serial port. They do accept a baudrate selection but just ignore it for the USB bus itself, it only applies to the last half-inch in the dongle you plug in the device. Whether or not the driver accepts 115200 as the maximum value is a driver implementation detail, they usually accept higher values.