Question

I have written a stored procedure given below….it should print the values I am printing using PRINT command. But rather printing these values, when I executed this procedure from Query Analyzer its shows ‘The command(s) completed successfully’. Can u suggest any modification in code or other solutions

Thanks in advance… 🙂

CREATE PROCEDURE  getPullCords(@start_dt varchar(25),@end_dt varchar(25))
 AS
declare @t varchar(25),@p varchar(50),@v int
declare @mycur CURSOR

SET @mycur  =  CURSOR FAST_FORWARD
FOR
select timestamp,point_id,_val from tcf1_pullcord where timestamp between @start_dt and @end_dt

OPEN @mycur
FETCH NEXT FROM @mycur
INTO @t,@p,@v

WHILE @@FETCH_STATUS = 0
BEGIN
PRINT @t
PRINT @p
PRINT @v
FETCH NEXT FROM @mycur
INTO @t,@p,@v
END

CLOSE @mycur
DEALLOCATE @mycur

GO

Answer 1

Whatever you’ve written to print data is correct.

However, if there is data to print then it is printing and you’ll not be able to the printed data Results tab.

To see your printed data choose Messages tab of the result section.

Thanks.