Question

Is there a way to set a breakpoint at every line in the code with GDB? Obviously I don’t want to hit b *addr for every single line, so I’m wondering if there’s a fast way to do this.

Edit
Note that I am running a binary created by someone else and I do not have access to the source code. Unfortunately, that binary has not been compiled with the -g flag. Therefore, I cannot just single step through each line in the code.

Further Edit
As Jason points out below, you can indeed single step through the code so long as you use si or ni, as opposed to just simply s (step) or n (next). n or s work fine, though, if the source code had been compiled with -g, but it steps through lines of source code, as opposed to stepping through every assembly instruction like ni or si do in a binary that was compiled without -g.

Answer 1

Use si (stepi) to instruction step through the code. You can use ni (nexti) to step over library functions you’re not interested in. If you accidentally step into one of them, finish should get you back to your original routine. People working at this level typically have gdb set to display the next few instructions that are about to be executed, e.g. disp/3i $pc.